GE Industrial Solutions 6KCV301ENC - Manual (Page 10)

———— Digital Encoder Input Expansion and Encoder Repeater ———— 10
GEI-100428
3.2.1 Divider for encoder repeater
The board has jumpers to set a divider ratio between the encoder repeater
frequency compared to the encoder input data.
The following divider settings are available: /1, /2, /4, /8.
The following table describes the phase shift between input and output.
Divider Description
A out channel is in phase with A in channel
B out channel is in phase with B in channel
C out channel is in phase with C in channel
A out channel edges are phased with either rising or falling edges
of A in (depending on initial condition)
B out channel edges are phased with either falling or rising edges
of A in (depending on initial condition)
C out channel raising edge is in phase with rising edge of C in
and the falling edge after two edges of A in and/or B in
A out channel is in phase with falling edge of A in channel
B out channel is in phase with falling edge of A in channel
C out channel rising edge is in phase with rising edge of C in
and the falling edge after five edges of A in and/or B in
A out channel is in phase with falling edge of A in channel
B out channel is in phase with falling edge of A in channel
C out channel rising edge is in phase with rising edge of C in
and the falling edge after nine edges of A in and/or B in
exp2F50ge
/1
/2
/4
/8