Asus P2-P5945GCX - Manual (Page 78)

5-24 Chapter 5: BIOS setup
Graphic Adapter Priority [PCI/Int-VGA]
Allows selection of the graphics controller to use as primary boot device.
Configuration options: [Internal VGA] [PCI/Int-VGA]
Internal Graphics Mode Select [Enabled, 8MB]
Sets the internal graphics mode. Configuration options: [Disabled] [Enabled, 1MB]
[Enabled, 8MB]
Graphics memory type [Auto]
Sets the graphics memory type. Configuration options: [Auto] [DVMT] [FIX]
[DVMT+FIX]
DRAM Frequency [Auto]
Allows you to set the DDR2 operating frequency.
Configuration options: [Auto] [DDR2-400MHz] [DDR2-533 MHz] [DDR2-667 MHz]
Selecting a very high DRAM frequency may cause the system to become
unstable! If this happens, revert to the default setting.
5.4.4 Chipset
The Chipset menu allows you to change the advanced chipset settings. Select an
item then press <Enter> to display the sub-menu.
Advanced Chipset Settings
Configure DRAM Timing by SPD [Enabled]
DRAM Frequency [Auto]
Graphic Adapter Priority [PCI/Int-VGA]
Internal Graphics Mode Select [Enabled, 8MB]
Graphic Memory Type [Auto]
Configure DRAM Timing by SPD [Enabled]
Allows you to enable or disable configure DRAM timing by SPD.
Configuration options: [Disabled] [Enabled]
Enable or disable
Configure DRAM Timing
by SPD