Installing an expansion card, Installing a sas card, I/o interface – Acer AT350 F1 User Manual
Page 76
3 System upgrades
64
Installing an expansion card
I/O interface
The AT350 F1 has six PCI bus slots with separate bus segments, namely:
•
Two PCI Express
®
2.0 x8 in x16 (slots 4 and 6)
•
Two PCI Express
®
2.0 x4 in x8 (slots 2 and 3)
•
One PCI Express
®
1.0 x4 in x8 (slot 5)
•
One PCI Express
®
2.0 x8 (slot 0 - Flex IO)
Installing a SAS card
1
Observe the pre-installation instructions on page 26.
2
Remove the side panel described on page 28.
3
If necessary, remove any cables that prevent access to the PCI slot.
4
Locate an empty expansion slot that is compatible with the
specification of the card you intend to install.
5
Unclip the restraining latch (1) and open in the direction (2) shown
below .
6
Remove the screw holding the slot in place (3).
7
Slide out the slot shield (4).