John Wood Noritz N-069M_N-069S - Manual (Page 41)

41
6.
Installation Clearances
Before installing, check for the following:
Install in accordance with relevant building and mechanical codes, as well as any local, state
or national regulations.
Caution
Item
Required Clearances
From Heater
• Maintain the following clearance from
both combustible and non-combustible
materials.
Check Illustration
12" Indoor
36" Outdoor
24" Outdoor
4" Indoor
2" Indoor
24" Outdoor
• If possible, leave 8" or more on either
side of the unit to facilitate inspection.
• If possible, leave 24" or more in front of
the unit to facilitate maintenance
and service if necessary.
Securing of space for
repair/inspection
24" or
more
8" or
more
8" or
more
Min: 3"
Min: 3"
• If the unit will be installed in the vicinity of a
permanent kitchen range or stove that has
the possibility of generating steam that
contains fats or oils, use a dividing plate or
other measure to ensure that the unit is not
exposed to air containing such impurities.
* The dividing plate should be of noncombust-
ible material of a width greater than the
water heater.
Exhaust hood
Range
Dividing plate Water
heater
(unit: inch)
Cooking Equipment