Front panel configuration port, Matrix sizes up to 1616, Installation, cont’d – Extron Electronics MAV Plus Series Setup Guide User Manual

Page 10

Advertising
background image

CrossPoint / MAV Matrix Switchers • Installation

Installation, cont’d

2-6

CrossPoint / MAV Matrix Switchers • Installation

2-7

Refer also to the CrossPoint 450 Plus / CrossPoint Ultra / MAV Plus User’s Manual at www.extron.com.

Refer also to the CrossPoint 450 Plus / CrossPoint Ultra / MAV Plus User’s Manual at www.extron.com.

h

Remote port

If desired, connect a control

system or computer to the rear panel Remote

RS-232/RS-422 port

.

N

Serial port defaults: RS-232, 9600 baud,

no parity, 8-bit, 1 stop bit, no flow control.

Pin Function

Pin#

Pin

Function

1

2

3

4

5

6

7

8

9

TX

RX

Gnd

Not used

Transmit

Receive

Not used

Ground

Not used

Not used

Not used

Not used

TX–

RX–

Gnd

RX+

TX+

Not used

Transmit –

Receive –

Not used

Ground

Not used

Receive +

Transmit +

Not used

Pin

Function

All Models

2412 — 3232

RS-422

RS-232

TX+

TX–

RX+

RX–

Gnd

Transmit +

Transmit –

Receive +

Receive –

Ground

Not used

Not used

Not used

Not used

Matrix Sizes:

2412 — 3232

Matrix Sizes:

84 — 1616

MAV Plus 248 / 328 A

i

LAN port — If desired, connect a network WAN or LAN hub, a

control system, or computer to the Ethernet RJ-45 port

.

Network connection

— Wire as a patch (straight) cable.

Computer or control system connection

— Wire the

interface cable as a crossover cable.

N

The factory default IP address is 192.168.254.254.

j

External Sync (MAV Plus) — If desired, attach an external sync

timing device to the external sync connector.

POWER

12V

0.5A MAX

L

R

1

4

3

2

1

6

5

PAL

NTSC

BLACKBURST

BLACKBURST/

COLORBAR

-10dBV

+4dBu

1 2 3

ON

1 KHZ AUDIO

BBG 6 A

BLACK BURST/COLOR BAR
/AUDIO GENERATOR

EXT

SYNC

Terminate cable
or connect to
another device.

Connect to
MAV Plus.

OUT

Extron
BBG 6 A

Black Burst Color Bar
Audio Generator

Figure 2-6 — External Sync connection

k

Power — Plug the switcher into a grounded AC source.

5

1

9

6

Front Panel Configuration Port

(Matrix Sizes up to 1616, MAV Plus 32 A, and

MAV Plus 248 A)

AUDIO

VIDEO

I/O

CONTROL

ENTER

PRESET

VIEW

ESC

CONFIG

ULTRA-WIDEBAND MATRIX SWITCHER

WITH

ADSP

CROSSPOINT

ULTRA

SERIES

12

Figure 2-7 — Front panel configuration port

l

Configuration port —

If desired, connect a control system

or computer to the front panel Configuration (RS-232) port.

Use an optional 9-pin D to 2.5 mm mini jack TRS RS-232

cable, part #70-335-01.

Advertising
This manual is related to the following products: