Extron Electronics MAV Plus Series Setup Guide - Manual (Page 21)

CrossPoint / MAV Matrix Switchers • Remote Control
Remote Control, cont’d
4-12 CrossPoint / MAV Matrix Switchers • Remote Control 4-13
Refer also to the CrossPoint 450 Plus / CrossPoint Ultra / MAV Plus User’s Manual at www.extron.com. Refer also to the CrossPoint 450 Plus / CrossPoint Ultra / MAV Plus User’s Manual at www.extron.com.
Accessing the HTML Pages
Another way to operate the switcher is via its factory-installed
HTML pages, which are always available and cannot be erased
or overwritten. The switcher’s HTML pages are accessible
through its LAN port, connected via a LAN or WAN, using a
web browser such as Microsoft Internet Explorer. See i on
page 2-6, for connection information.
Loading the start-up page
N If your Ethernet connection to the matrix switcher is
unstable, try turning off the proxy server in your Web
browser. In Microsoft Internet Explorer, click Tools >
Internet Options
> Connections > LAN Settings,
uncheck the Use a proxy server... box, and then click
OK
.
N For details on operating the switcher via HTML pages,
refer to the CrossPoint 450 Plus / CrossPoint Ultra /
MAV Plus Switcher Manual, chapter 6, “HTML
Operation” .
1 . Start the Web browser program.
2 . Click in the browser’s Address field.
3 . Enter the Matrix IP address in the browser’s Address field.
N 192.168.254.254 is the factory-specified default value for
this field.
4 . Press the keyboard Enter key. The switcher checks to see if
it is password protected.
If the switcher is not password protected , it checks and
downloads the HTML start-up page. The switcher is ready
for operation via HTML remote control.
If the switcher is password protected , the switcher
downloads the Enter Network Password page.
N A User name entry is not required.
5 . Enter the appropriate administrator or user password in
the Password field and click OK.
6 . The switcher downloads the HTML start-up page. The
switcher is ready for operation via HTML remote control.