Extron Electronics MAV Plus Series Setup Guide - Manual (Page 4)

i CrossPoint / MAV Matrix Switchers • Table of Contents
Table of Contents
Refer also to the CrossPoint 450 Plus / CrossPoint Ultra / MAV Plus User’s Manual at www.extron.com.
Chapter One • Introduction .................................................... 1-1
About this Manual .................................................................... 1-2
About the Matrix Switchers ................................................... 1-2
Chapter Two • Installation ...................................................... 2-1
Rear Panel .................................................................................... 2-2
Making connections and rear panel settings ....................... 2-4
Front Panel Configuration Port
(Matrix Sizes up to 1616,
MAV Plus 32 A, and MAV Plus 248 A)
................................. 2-7
Chapter Three • Front Panel Operation .......................... 3-1
Creating a Tie .............................................................................. 3-2
Saving or Recalling a Preset ................................................... 3-3
Setting the Front Panel Locks (Executive Modes) ........... 3-4
Selecting Lock mode 2 or toggling between mode 2 and
mode 0 .................................................................................... 3-4
Selecting Lock mode 2 or toggling between mode 2 and
mode 1 .................................................................................... 3-5
Viewing and Adjusting the Audio Level ............................ 3-5
Viewing Ties (and Muting Outputs) .................................... 3-6
Chapter Four • Remote Control ........................................... 4-1
Selected SIS Commands ........................................................... 4-2
Establishing a network (Ethernet) connection .................... 4-2
Connection timeouts ..............................................................4-2
Number of connections ..........................................................4-3
Verbose mode .........................................................................4-3
Host-to-switcher instructions ................................................4-3
Installing and Starting the Control Program .................... 4-9
Installing the program ........................................................... 4-9
Starting the program ........................................................... 4-10
Accessing the HTML Pages ................................................... 4-12
Loading the start-up page ................................................... 4-12
All trademarks mentioned in this manual are the properties of their respective owners.
68-521-50 Rev. B
07 09