Extron Electronics MAV Plus Series Setup Guide - Manual (Page 20)

CrossPoint / MAV Matrix Switchers • Remote Control
Remote Control, cont’d
4-10 CrossPoint / MAV Matrix Switchers • Remote Control 4-11
Refer also to the CrossPoint 450 Plus / CrossPoint Ultra / MAV Plus User’s Manual at www.extron.com. Refer also to the CrossPoint 450 Plus / CrossPoint Ultra / MAV Plus User’s Manual at www.extron.com.
4 . Follow the on-screen instructions. The installation
program creates a C:\Program Files\Extron\
Matrix_Switchers directory and an “Extron Electronics\
Matrix Switchers” group folder. It installs the following
four programs:
•
MATRIX Switcher+ Control Program
• MATRIX Switcher+ Help
• Uninstall MATRIX Switcher
• Check for Matrix Updates
Starting the program
1. Click Start > Programs > Extron Electronics > Matrix
Switchers
> MATRIX Switcher + Control Pgm.
The Comm Port Selection window appears.
2 . Choose the comm (serial) port that is connected to the
switcher or IP [LAN].
N For a comm port, check the baud rate displayed in the
comm port selection window. If you need to change the
baud rate, click the Baud button and double-click the
desired baud rate.
Click OK.
If you selected a serial port in step 2 , the Matrix Switchers
Control Program is ready for operation.
3 . If you selected IP [LAN] in step 2 , the IP Connection
window appears.
a . Examine the Matrix IP Address field, which displays
the last Matrix IP address entered.
If necessary , enter the correct IP address in the field.
N 192.168.254.254 is the factory-specified default value for
this field.
b . If the switcher is password protected, enter the
appropriate administrator or user password in the
Password field.
c . Click Connect. The Matrix Switchers Control Program
is ready for operation.