Installing and starting the control program, Installing the program – Extron Electronics MAV Plus Series Setup Guide User Manual
Page 19
CrossPoint / MAV Matrix Switchers • Remote Control
4-9
Refer also to the CrossPoint 450 Plus / CrossPoint Ultra / MAV Plus User’s Manual at www.extron.com.
Installing and Starting the Control Program
Another way to operate the switcher is via the Windows
®
-based
Matrix Switchers Control Program. This program is contained
on the Extron Software Products Disk (included with the
switcher). Run this program on a PC connected to either of the
switcher’s serial ports or the Ethernet port. See
, and
,
on pages 2-6 and 2-7, for connection information. The program
must be installed on a Windows-based computer and cannot be
run from the disk.
N
For details on operating the program, refer to the
CrossPoint 450 Plus / CrossPoint Ultra / MAV Plus
Switcher Manual, chapter 5, “Matrix Software”.
Installing the program
1
.
Insert the disk into the drive. The installation program
should start automatically.
The Extron software disk window appears.
N
If the installation program does not self-start, run
Launch.exe from the disk.
2
.
Click the Software tab.
3
.
Scroll to the Matrix Switchers program and click Install.