Extron Electronics MAV Plus series Large Scale Setup Guide - Manual (Page 16)

Cr
ossPoint / MA
V Matrix Switchers • Remote Contr
ol
Remote Contr
ol, cont’d
4-6
Cr
ossPoint / MA
V Matrix Switchers • Remote Contr
ol
4-7
Refer also to the
Cr
ossPoint 450 Plus / MA
V Plus User’
s Manual
at
www
.extron.com
.
Refer also to the
Cr
ossPoint 450 Plus / MA
V Plus User’
s Manual
at
www
.extron.com
.
Command ASCII command
(host to switcher)
Response
(switcher to host)
Additional description
Audio output volume
Set the audio volume to a specific
value X@ * X% V Out X@ •Vol X%]
Example: 1*50v Out01•Vol50 ] Set output 1 volume to an X% value of 50, an
attenuation of 14 dB (79% of total volume).
Increment volume X@ +V Out X@ •Vol X%] Increase volume by 1 step.
Example: 1+V Out01•Vol51 ]
Decrement volume X@ -V Out X@ •Vol X%] Decrease volume by 1 step.
Read output volume X@ V X%]
Save and recall presets
N • If you try to recall a preset that is not saved, the matrix switcher responds with the error code E11.
• The following characters are invalid in preset names: + - , ` @ = [ ] { } ‘ “ ; : | \ and ?.
Save current configuration as a
global preset X^, Spr X^] Command character is a comma.
Example: 9 , Spr09 ] Save current ties as preset 9.
Recall a global preset X^. Rpr X^] Command character is a period.
Example: 5 . Rpr05 ] Recall preset 5, which becomes the current
configuration.
Command ASCII command
(host to switcher)
Response
(switcher to host)
Additional description
Lock (executive) modes
N See “Setting the front panel locks (Executive modes)” on page 3-4 for more information on the Lock modes.
Lock all front panel functions 1X Exe1 ] Enable Lock mode 1.
Lock advanced front panel functions 2X Exe2 ] Enable Lock mode 2.
Unlock all front panel functions 0X Exe0 ] Enable Lock mode 0.
View lock status X X&]
N X& = Lock mode 0, 1, or 2
N X@ = Output number 01 – (maximum number of outputs for your model)
X% = Volume 0 – 64 (1 dB/step except for 0-to-1, which is 22 dB) (default = 64 [0 dB])
X^ = Preset number 00 - 64 (00 = current configuration, for viewing only)