Extron Electronics MAV Plus series Large Scale Setup Guide - Manual (Page 4)

i CrossPoint / MAV Matrix Switchers • Table of Contents
Table of Contents
Refer also to the CrossPoint 450 Plus / MAV Plus User’s Manual at www.extron.com .
Chapter One • Introduction ..................................................... 1-1
About this Manual ..................................................................... 1-2
About the Matrix Switchers .................................................... 1-2
Chapter Two • Installation ....................................................... 2-1
Rear Panel Installation Features ............................................ 2-3
Video and audio connections, sync termination, and external
sync.......................................................................................... 2-3
Remote control connections.................................................. 2-4
BME connection and selection............................................... 2-5
Power connection................................................................... 2-6
Front Panel Configuration Port .............................................. 2-6
Chapter Three • Front Panel Operation .......................... 3-1
Creating a Tie ............................................................................... 3-2
Saving or Recalling a Preset .................................................... 3-3
Setting the Front Panel Locks (Executive Modes) ............ 3-4
Selecting Lock mode 2 or toggling between
mode 2 and mode 0................................................................ 3-4
Selecting Lock mode 2 or toggling between
mode 2 and mode 1................................................................ 3-5
Viewing and Adjusting the Input Audio Level and
Output Volume....................................................................... 3-5
Viewing Ties (and Muting Outputs) ..................................... 3-6
Chapter Four • Remote Control ............................................ 4-1
Selected SIS Commands ........................................................... 4-2
Establishing a network (Ethernet) connection..................... 4-2
Connection timeouts...............................................................4-2
Number of connections...........................................................4-3
Verbose mode..........................................................................4-3
Installing and Starting the Control Program ................... 4-10
Installing the program.......................................................... 4-10
Starting the program............................................................ 4-11
Accessing the HTML Pages .................................................... 4-13
Configuring for Network Communication.......................... 4-13
Loading the start-up page.................................................... 4-15
All trademarks mentioned in this manual are the properties of their respective owners.