Extron Electronics CrossPoint Plus Matrix Switchers 84, 88, 124, 128, 168, 1616 HV and HVA - Manual (Page 28)

Operation, cont’d
CrossPoint Plus Matrix Switchers • Operation 3-8
1
1
2
2
3
3
4
4
5
5
6
INPUTS
ENTER
OUTPUTS
6
7
7
8 9 10 11
PRESET VIEW ESC RGBHV AUDIO
12
8
CONTROL I/O
Press
Press
Press
Press
Press
ESC
RGBHV
A
B
ENTER
E
C C
1
3 8 4
5
C
D
B
F
B LED key: = off, = on, = blinking,
= flash once F
Figure 3-6 — Example 2: Adding a video tie
E Press and release the Enter button. The input and output LEDs turn off. The
current configuration is now defined as video input 5 tied to video output 1,
output 3, output 4, and output 8; and audio input 5 tied to audio output 3,
output 4, and output 8.
Example 3: Remove a tie from a set of video and audio ties
See figure 3-7 and the following steps for an example in which an existing audio tie
is removed from the current configuration.
1
1
2
2
3
3
4
4
5
5
6
INPUTS
ENTER
OUTPUTS
6
7
7
8 9 10 11
PRESET VIEW ESC RGBHV AUDIO
12
8
CONTROL I/O
C
ESC
AUDIO
A
B
5
C
8
C
4 3
F
LED key: = off, = on,
= flash once F
Press
Press
Press
Figure 3-7 — Example 3: Selecting audio, selecting input 5
A Press and release the Esc button. The Esc LED flashes once.
B If necessary to select audio-only for the tie, press and release the RGBHV and
Audio buttons until the RGBHV LED is off and the Audio LED lights.
C Press and release the input 5 button. The input 5 LED lights. If the steps in
Example 1 have been completed, the output 3, output 4, and output 8 LEDs
light to indicate ties created in Example 1.
The output 1 LED does not light even if the steps in Example 2 were completed
because Example 2 added a video tie only.
D Press and release the output 4 button (figure 3-8). The output 4 LED turns off,
while the output 3 and output 8 LEDs remain lit.