Extron Electronics CrossPoint Plus Matrix Switchers 84, 88, 124, 128, 168, 1616 HV and HVA - Manual (Page 48)

Programmer’s Guide, cont’d
CrossPoint Plus Matrix Switchers • Programmer’s Guide 4-6
Command/response table for SIS commands (Cont’d)
Command ASCII Command Response Additional description
(host to switcher) (switcher to host)
Start direct write of global presets Esc P X11 Write Preset X11 Ready Allows direct entry of presets.
{Tie commands} {Define ties for preset.}
End direct write of global presets Esc p End Write Preset X11 Saves directly written presets.
Quick recall preset Esc
.
Rpr X11 Command character is a period.
1. This sequence of commands forces the switcher to perform a complete backplane switch
within 60 msecs of receipt of the Quick recall command.
2. The switcher ignores any invalid command or non-switching commands received between
the Start and End commands.
3. If there is no activity for 5 seconds, the switcher returns the timeout (E17) error.
4. The switcher disables front panel switching during this sequence of commands.
5. The switcher returns the invalid command (E10) error if it receives the End command
without the start command or the Quick recall command without a prior direct preset write.
6. The switcher must receive the Quick recall command within 100 msecs of the End
command.
Example:
Esc P14 Write Preset 14 Ready Creates new preset 14 with:
1*3! A & V Input 1 tied to output 3.
7*8% Video input 7 tied to output 8 1 .
10*4& RGB input 10 tied to output 4 1 .
12*4$ Audio input 12 tied to output 4.
Esc p End Write Preset 14 Stops entry, saves preset 14.
Esc
.
Rpr X11 Recalls the preset.
Video mute commands
Video mute X2 *1B Vmt X2 *1 Mute output X2 video (video
off).
Video unmute X2 *0B Vmt X2 *0 Unmute output X2 video (video
on).
Read video mute X2 B X13 1= mute on, 0 = mute off.
Global RGB mute 1*B Vmt1
Global RGB unmute 0*B Vmt0
Audio mute commands
Audio mute X2 *1Z Amt X2 *1 Mute output X2 video (audio
off).
Audio unmute X2 *0Z Amt X2 *0 Unmute output X2 video (audio
on).
Read audio mute X2 Z X13 1= mute on, 0 = mute off.
Global audio mute 1*Z Amt1
Global audio unmute 0*Z Amt0
Executive mode
Lock front panel X Exe1 Enable executive mode.
Unlock front panel x Exe0 Disable executive mode.
Resets
Reset global presets Esc zG ZapG•• Clear all global presets.
Reset delays Esc zD ZapD•• Reset all switch intervals to 0 sec.
Reset audio levels Esc zA ZapA•• Reset all audio levels to 0dB.
Reset grouping Esc zP ZapP•• Reset all I/O grouping.