IPX DDK-1000 - Manual (Page 52)

Change the Application Setting — Alarm - Motion Detection.
Please follow the steps below to enable changes in the motion detection function of the alarm
Set the motion d
1. Click the Motion Detection button on the left side of the Alarm to enter the “Alarm – Motion
Detection” page.
through the network if necessary.
etection:
2. Click and drag the mouse across a targeted zone to draw a red rectangle on the image
(coordinates provided below).
NOTE: You can set more than one targeted zone depending on your requirement.
Submit f the recording.
turn to the home page.
3. Enables / disables the motion detection function.
4. Set up the signal level.
the button to submit the new setting o 5. Click
6. Click the Home button to re
Description of function keys:
The targeted zone: Click and drag the mouse across the targeted zone to draw a red rectangle
Detection Range: The red rectan dinates.
Motion Detection: This option enables / disables the motion detection function.
Sensitivity Level: You can select any one of the given options for the setup signal level or just
type in the value of Customized Threshold.
on the image.
gle’s coor
Save: Click to save the motion detection range.
50