Unibor Hydrobor HUW150 - Manual (Page 8)

8
DRILL GUARD INSTRUCTIONS
Ensure drill unit is isolated from power supply.
TYPE 1 - This type uses a single screw to fix the
guard to the drill.
Fit guard to drill in position shown in fig. 1.
Secure the guard to drill with the screw supplied.
DO NOT overtighten the fixing screw, this should
be loose enough to allow the guard to rise when
required. Lower the guard to drilling surface.
When drilling, the guard should always be in
contact with the surface being drilled. As the
drill is lowered, the guard will rise in relation
to the drill.
TYPE 2 - This type uses two screws to support the
guard in position, one either side of the drill.
If necessary press the plastic guard guides into
their locating holes on ether side of the motor
cradle
Fit guard to drill as shown in fig 2.
Secure guard to drill with screws and washers
supplied. DO NOT overtighten the fixing screws,
these should be loose enough to allow the guard
to rise when required. Lower guard to drilling
surface.
When drilling, the guard should always be in
contact with the surface being drilled. As the
drill is lowered, the guard will rise in relation
to the drill.
FITTING THE CUTTER (S
TANDARD
A
RBOR
)
Fig. 1
Fig. 2
Fig. 3
Fig. 4
F
ITTING THE
S
AFETY
G
UARD
ENGLISH