Avision AV8000S - Manual (Page 11)

2-4
2.3 SETTING SCSI TERMINATOR AND
SYNC
The scanner is equipped with a built-in terminator
switch on the rear of the
scanner. (See Figure 2-2/2-
3).Turn the terminator switch on if the scanner is to be
connected to the computer as the only or the last SCSI
device. Turn the terminator switch off if the scanner is to
be located between the computer and the other SCSI
device.
The scanner is also equipped with a built-in SYNC
switch on the rear of the scanner. (See Figure 2-2) .The
factory default setting is ON. Turn the SYNC switch off if
the SCSI card connected to your computer is not
compatible with AV8000S or your computer can not find
the AV8000S.
Figure 2-2 Adjusting the SCSI ID/Terminator/SYNC
settings
SCSI ID Selector
ON OFF
Terminator
ON OFF
SCSI SYNC
SCSI Connector ADF Connector