Trouble shooting – Avision AV8000S User Manual
Page 46
7-1
7.
TROUBLE SHOOTING
The scanner will automatically perform a simple
self-test each time it is turned on. This will help
spot major system errors in the scanner itself.
When the test is initiated, the READY/Error LED is
flashing. When the test is completed, if no error occurs,
the READY/Error LED is steadily on.
If you have problems with the operation of your scanner,
please check the following troubleshooting hints.
7.1
QUESTION AND ANSWER
Question: The READY/Error LED indicates that
the scanner is ready, but the scanner
does not respond to the scan
command from the host computer.
Answer:
a) Please check if the signal cable is
firmly seated, and invoke the scan
command again. If there is still no
response, please reset the scanner
by turning it off and then on again,
and reboot your host computer as
well.
b) Check if the driver is correctly
installed.