Kaiser С вертикальной загрузкой - Manual (Page 10)

EN
Max 900 mm
Min 600 mm
1
2
3
4
Connecting the drain hose
• Connect the drain hose 1 to the drain pipe 2
(diameter: 40 mm min.), or let it run directly into
the sink 3.
Use the special plastic hose support 4 which is
delivered with the appliance.
• Make sure that the hose is free from being bent or
flattened.
The free end of the hose must be at a height of 400 to
1000 mm and must not be immersed.
Disconnecting from water supply and sewerage
• To disconnect the Aqua-Stop inlet hose, cut off
water supply by turning off the faucet, screw out
the nut of the safety inlet hose which adjusts it to
the faucet.
• Put the hose into the special storage
compartment at the back of the dishwasher.
In case the free end of the hose is put directly into the
sink, pay attention to the following:
If the sink is mounted at the height of 100 cm from the
floor, the excess water cannot be drained directly into
the sink.
To drain the excess water from the hose in this case,
you need a pail or any other suitable container which
should be put below the sink at the side of it
10