Camco D-Power 4 - Manual (Page 19)

4 OPER
ATION
USER MANUAL
D - P O W E R S E R I E S P. 8
D - P O W E R
S E R I E S
4.2.3 I-Out LEDs
The brightness is proportional to the output current in the corresponding channel.
4.2.4 Clip LEDs
This LED indicates an overloading of the amplifier when the power output level
is too high.
4.2.5 Mode Indicators
On the front panel there are two yellow LEDs to indicate the mode that is set. In
stereo mode (2-channel) none of them will be lit. In Parallel-Mono the (PM) LED
will be lit and in Mono-Bridge, the (MB) LED will be lit.
Amplifier in Parallel-Mono mode
Amplifier in Mono-Bridge mode