Castle TSM-35 Operator Manual - Manual (Page 16)

CASTLE, INC TSM-35 OWNERS MANUAL V1.2 Page 16 of 33
5.6 Left and Right Router Adjustment
The ideal location for the router bit is to be directly in the center of the slot provided on the Case
Top. If you find that the bit has moved to the left or right of the slot, your TSM-35 has a Left and
Right Router Adjustment.
Fig 6
1. Turn off Air and Electrical power to the machine and raise the Case Top to its fully
opened position.
2. There are two Jacking Screws on each side of the machine. The top Jacking Screws are
for the router carriage.
3. Use a 7/16” wrench to loosen the ¼ -20 Nylock nut on each side of the machine.
4. Once the Nylock nuts are loose, use a 1/8” Allen wrench to move the carriage left and
right. Loosen the left side and tighten the right to move the carriage to the left. Loosen
the right side and tighten the left to move the carriage to the right.
5. Once you have adjusted the Jacking Screws, apply air and power to the machine and cut
a test pocket.
6. If the pilot hole is in the appropriate position for the particular application, use a 1/8” Allen
wrench to secure each Jacking Screw while tightening the ¼-20 Nylock nut with 7/16”
wrench on both sides of the machine.