Castle TSM-35 Operator Manual - Manual (Page 19)

CASTLE, INC TSM-35 OWNERS MANUAL V1.2 Page 19 of 33
5.9 Drill Delay Adjustment
If you find that, in a particular application, your drill bit sticks in the material, a possible cause is
that your drill has shut off before the drill bit exits the pilot hole. To test for, and fix this problem
your TSM-35 is equipped with a Drill Delay Adjustment.
Fig 9
1. Turn off Electrical power to your machine and raise the Case Top to its fully opened
position.
2. Locate the Drill Delay flow control mounted next to the drill.
3. To keep the drill spinning longer, loosen the jam nut on the flow control, then turn the
knob clockwise ½ turn. Please note that this ONLY controls how long the drill stays on
during the cycle. The drill should NOT remain spinning indefinitely.
4. Close the Case Top, restore power, and cut a test pocket. Repeat this process if neces-
sary.
5. Once you have found the proper adjustment, tighten the jam nut on the flow control to
ensure your machine stays in adjustment.
5.10 Drill Stop Switch
Your TSM-35 has a switch that tells the drill to retract when it reaches its maximum travel. This
switch may come out of adjustment and you may find that the drill goes forward, but does not