American Dish Service Vision C3 - Manual (Page 15)

2-1
Installation
54-0159 Rev. G
2 Installation
TracVision C3 is designed for simple installation and setup. Just
follow these easy steps:
Step Refer to Section...
1. Choose the hardware locations 2.1
2. Mount the antenna unit 2.2
3. Connect system components 2.3
4. Activate the IRD 2.4
5. Select the active satellite 2.5
6. Set the skew angle (Europe only) 2.6
7. Check out the system 2.7
Installation Tools and Materials Required
• Electric drill
• 3 ⁄
8
" (9.5 mm), 3 ⁄
16
" (5 mm), 5 ⁄
32
" (4 mm), and
3 ⁄
32
" (2.5 mm) drill bits and 3 ⁄
4
" (19 mm) hole saw
and auger bit
• 1 ⁄
2
" wrench
• #2 Phillips and #0 flat tip screwdrivers
• RG-6 or RG-11 (75 ohms) RF cable (if installing
two RF cables - refer to
Section 2.3.5 for details)
• Silicone sealant, RTV, or Sikaflex
• 7 ⁄
16
" open end wrench
• PC with terminal emulation software such as
PROCOMM or Windows Terminal or
Hyperterminal
Plan the entire installation before
proceeding! Take into account
component placement, cable
running distances between units,
and accessibility to the equipment
after installation.
Table 2-1
Installation Process