American Dish Service Vision C3 - Manual (Page 61)

5.5 Preparation for Shipment
If it is necessary to repack the antenna unit for shipment, the
shipping restraints removed during installation must be
replaced. Follow these steps to reinstall the restraints.
1. Rotate the antenna unit so that the LNB is facing
away from the baseplate connectors.
2. Attach the three restraints to the baseplate using
the 1 ⁄
4
"-20 x 5 ⁄
8
" hex screws and washers (provided
as part of the kitpack) and nuts (removed from the
shipping restraints during installation) as pictured
in Figure 5-8.
3. Place the antenna bracket on the forward shipping
restraint.
4. Secure the forward restraint and bracket by
wrapping two tie-wraps around the bend in the
forward restraint and the antenna bracket (at the
end of the LNB bracket).
5. Place the entire antenna unit into its shipping box
using the original packaging material.
5-9
Maintenance
54-0159 Rev. G
When rotating the azimuth
mechanism by hand, go slowly!
Hitting the mechanical stops with
excessive force will damage the
azimuth limit switch.
Figure 5-8
Attaching the Shipping Restraints
to the Antenna Baseplate
Figure 5-9
Securing the Forward
Shipping Restraint
2 tie-wraps used
to secure LNB arm
Forward Shipping Restraint
Forward Shipping Restraint
Nuts and Washers
Hex Screws and Washers
KVH is not liable for damage
caused by improper shipping.