American Dish Service Vision C3 - Manual (Page 21)

2-7
Installation
54-0159 Rev. G
14. At each hole, place a 1 ⁄
4
" flat washer on a
1 ⁄
4
"-20 x 3" bolt (from the kitpack) and insert it into
the mounting hole from above (see Figure 2-9).
15. Apply a flat washer, lock washer, and nut
(removed in Step 7 ) to each mounting bolt from
below decks and tighten securely.
16. When the antenna unit is installed with the
baseplate connectors facing the stern of the vessel,
the drain holes are located as shown in
Figure 2-10.
Figure 2-10
Baseplate Connectors Facing Rear
of Vessel – Factory-drilled
Drain Hole Locations
Factory-drilled
Drain Hole Positions
Bow
Bolt
Flat Washer
Mounting Plate
Deck
Flat Washer
Hex Nut
Silicone
Lock Washer
TracVision
Baseplate
Silicone
Figure 2-9
Securing TracVision C3
to the Deck