Antex Electronics SX-5e - Manual (Page 32)

27
Volume:
These controls allow changing the volume of the playback
only.
INSTALLING AND USING MULTIPLE CARDS IN A SYSTEM
When using more than one card in a system, each card must
have a different adapter number. This is set by using the jumpers
on top of the card. The Antex Driver must be set up to have a
different Address and Interrupt for each card. In Win NT, go to
“Start”, “Settings”, “Control Panel”, “Multimedia”, “Devices”, “Audio
Devices”, “Audio for Antex Digital Audio Driver”, “Settings”. For
each adapter number, make sure the correct model card is se-
lected and that there is a different Address and Interrupt for each
card. Each device on each card is accessible in the Antex Demo
by using the pull down menu. Open as many instances of the
Antex Demo as needed to access the desired number of de-
vices/cards.
DUAL DEVICE OPERATION
Dual device mode can be accessed by opening 2 instances of the
Antex Demo application. Note that in this mode, both devices
(files) must have the same sample rate. File formats do not have
to be the same. For example, you can play back a PCM16 file
and an MPEG file at the same time, provided they are both re-
corded at the same sample rate. The limiting factor in dual device
mode is the processing power of the DSP. The tables below
show the capabilities of each card.