Antex Electronics SX-5e - Manual (Page 57)

52
Specifications
Unless otherwise noted, THD+N and Dynamic Range measure-
ments are done at 1KHz, A weighting, 48 KHz sample rate.
Maximum input and output levels are for digital full scale.
All Cards (as applicable):
Sample rates ............................ 8, 11.025, 16, 22.05, 44.1, 48 KHz
Frequency Response ...............................20Hz to 20KHz, +/- .5dB
Mic input level...............................................................10mV RMS
Mic input impedance......................................................... 1K ohms
Mic phantom power ......................... 2.5VDC w/ 2K limiting resistor
SX-36:
THD+N ........................................................................... .02% max
Dynamic Range ................................................................ 80 B min
Balanced Output level, low trim ............................................+8dBu
Balanced Output level, high trim .........................................+20dBu
Balanced Output impedance (each leg)............................ 50 ohms
Balanced Output load impedance.............................600 ohms min
Line In/ Aux In level, low trim ................................................+8dBu
Line In/ Aux In level, high trim.............................................+20dBu
Line In/ Aux In input impedance............................... 25K ohms min
DSP............................................................... TMS320C32, 60MHz