Antex Electronics SX-5e - Manual (Page 6)

1
INTRODUCTION
The Antex SX-5e, SX-6, SX-34 and SX-36 family of cards are ISA
bus audio “add-in” cards for the PC. They all incorporate DSP’s
(Digital Signal Processors), which allow the cards to do a variety
of audio formats. (MPEG, PCM16, MSADPCM, etc.) All cards are
dual device, which means they can operate on 2 hard drive files at
the same time. These cards operate at several fixed standard
sample rates: 8, 11.025, 16, 22.05, 32, 44.1, and 48 KHz. The
SX-5e and SX-6 are playback only cards, and the SX-34 and SX-
36 have playback and record capability. The SX-5e and SX-34
have unbalanced analog I/O and the SX-6 and SX-36 have bal-
anced analog I/O. Up to 4 cards may be installed into one com-
puter.
Software is provided for Win95/98, and WinNT. Software in-
cludes the “driver”, the Antex Demo application, Antex Mixer ap-
plication, and Antex VU Meter application. Contact Antex Techni-
cal Support or visit the Antex website (www.antex.com), for infor-
mation about DOS or Windows 3.11 drivers, or the Software De-
veloper’s Kit (SDK).
CARD INSTALLATION
Make sure the main power to your computer is OFF. You will
need a 16 bit/AT slot. If you are unfamiliar with the internal design
of your computer see its "Guide to Operations" manual for step by
step installation procedures. To avoid damaging the board or
your computer with static electricity:
1. Touch the metal of your computer chassis first to discharge
the static electricity from yourself before opening the antistatic
bag the Antex Card is packaged in.
2. Move around as little as possible. Don’t shuffle your feet on
carpet or move around in your chair.
3. Handle the card by the bracket and the edges. Try not to
touch the gold fingers or any of the parts on the board.