CEMB USA K8 (B) - Manual (Page 8)

I 0457 - 8
5
b
GB
5 - Instructions for use of the wheel balancer
5.1 - Setting the wheel dimensions
a)
DYNAMIC balancing of steel or light alloy rims with application of clip-on
weights on the edge of the rim.
From the measurement frame, press inside and outside to select the desired correction mode.
The illuminated LEDs indicate the position where the weights should be applied. If a spin has already been carried
out, each time the mode is changed, the processor automatically recalculates the unbalance values on the basis of
the new setting.
- Set the distance “a” between the inside of the wheel
and the machine
- Set the nominal width, normally indicated on the
rim, or measure the width “b” using the caliper
gauge supplied.
- Set the nominal diameter “d” indicated on the tyre.
Reading
- Measuring
- Setting
The STATIC mode is required for motorcycle wheels or when it is not possible to
place the counterweights on the two sides of the rim.
Balancing of light alloy rims with application of adhesive weights on the shoulders of
the rims. The position of the weights is fixed from the edges of the rim to the inside of
the rim.
Combined balancing: adhesive weight on the outside and clip-on weight on the inside.
The position of the outside weight is fixed from the outside edge of the rim to the inside
of the rim.
Combined balancing: adhesive weight on the inside and clip-on weight on the
outside. The position of the inside weight is fixed from the edge of the rim to the inside
of the rim
This setting is also valid for the following correction modes: