CEMB USA N100 - Manual (Page 48)

7 - 12 CEMB N-Pro program (optional)
4. value (in generic U units) and phase of the final imbalance (that is to say after
balancing)
5. value and phase of the final vibration (that is to say after balancing)
6. velocity of the rotating part
7. balancing information and parameters
8. notes associated with balancing
The notes associated with each measurement can be entered or edited at any time by
pressing
. This is a valid help in the post-data analysis stage: the user can add
comments or notes related to the values or type of measurement, but also regarding the
acquisition conditions. Reminders for future work can be added, or other important notes.
For example, in the case of balancing it is recommended to specify what physical units (mg,
g, kg, g· mm, g· cm, g· m, …) the generic U units correspond to.
Generation and printing of certificates ( reports )
CEMB N-Pro software can be used to create and print customised certificates of vibration
analysis and balancing results with extreme ease.
Press the key, then select a model (template) for the certificate to be generated. The
model is a simple HTML file that the same user can create and customise to suit his own
needs using any HTML editor. The CEMB N-Pro program generates the report
automatically replacing some preset codes in the template with the corresponding values of
the measurement displayed.
The result is then displayed in a window and the following functions are enabled:
save the report just generated, specifying the name and position
print the report displayed, selecting a printer from those installed on the PC
Note: If a virtual PDF printer is installed on the PC (e.g. PDFCreator, …), select
that to obtain a copy of the certificate in PDF format instead of a hard copy. It can
then be named and saved on the hard disk in the desired location, so that it can be
filed or even sent by e-mail.
A hard copy can be obtained at a later date if required by printing off a copy of the
PDF document.