CHIEF WM2 Series - Manual (Page 22)

Installation Instructions
22
Cable Management (Optional)
In most cases, cable management covers will NOT need to be
removed in order to route cables from projector to the wall
mount. But for some thick cables, removing the covers may be
necessary.
Removing Mount Covers
1. Remove and save two 8-32 x 1/2" Phillips pan head screws
(F) from upper cover. (See Figure 52)
2. Raise upper cover away from the mount. (See Figure 52)
Figure 52
3. Remove lower cover from mount. (See Figure 53)
Figure 53
4. Remove cable management covers (if necessary) from
short throw projector arm. (See Figure 54)
Figure 54
NOTE: Cables may be routed from below and up wall bracket
channel, or from above and down behind and into wall
mount.
• Routing Cables from Below (Steps 5 and 6)
5. Open cable clips along bottom edge of wall bracket. (See
Figure 55)
Figure 55
6. Thread cable up wall bracket channel and into opened
cable clips. (See Figure 56) Proceed to Step 8
Figure 56
1 (F) x 2
2
3
(bottom view)
4
4
Cable
management
covers
cable clips
x 4
5
Cables (example)