CHIEF WM2 Series - Manual (Page 23)

Installation Instructions
23
• Routing Cables from Above (Step 7)
7. Thread cables down through a surface mount cable
accessory (not included), then behind and into the wall
bracket. (See Figure 57) Proceed to Step 8
Figure 57
8. Route cables through cover mount, projector arm tunnel
and into projector. (See Figure 58)
Figure 58
9. (Optional) Cables can be tied to inside of mount’s front
cover using cable ties (not included). Route cables near
front cover and wrap cable tie through slots on front cover
and around cables. (See Figure 59)
Figure 59
10. Replace removed cable management covers (if necessary).
Insert one side of cover into groove and press firmly on the
cover on the other side until it snaps into the other groove.
(See Figure 60)
Figure 60
11. Return outer covers to the mount following instructions in
Installing Mount Covers section.
Installation of Wall Bracket Covers
NOTE: If security screws are going to be used, use the security
screws (V) to install wall bracket covers. See Security
Screw Installation section for details.
(view from back)
(view from front)
Surface Mount
Cable Accessory
(not included)
Cables
Cables
7
7
Cable clips
Cables (example)
Cable tie (not included)
Route through slots and
around cables
9
10