AllTrade BAR916HG - Manual (Page 11)

EN
11
SWITCH OPTION
Temp °C / °F
SWITCH OPTION
Channel If you are using more than one
sensor, select a different channel
for each sensor
Radio Signal
Format EU (DCF) / UK (MSF)
The RTGR328N Sensor collects temperature and
humidity readings, and signals from official time-keeping
organizations for the radio-controlled clock.
S
SET UP THERMO / HYGRO
SENSOR (RTGR328N)
1. Open the battery compartment with a small Phillips
screwdriver.
2. Insert the batteries.
3. Set the channel and radio signal format. The
switches are located in the battery compartment.
4. Press RESET. Then set the temperature unit.
5. Close the battery compartment.
To fold out the stand:
1
2
For best results:
• Insert the batteries and select the unit, channel, and
radio signal format before you mount the sensor.
• Place the sensor out of direct sunlight and moisture.
• Do not place the sensor more than 70 metres
(230 feet) from the main (indoor) unit.
• Position the sensor so that it faces the main
(indoor) unit, minimizing obstructions such as doors,
walls, and furniture.
• Place the sensor in a location with a clear view to the
sky, away from metallic or electronic objects.
• Position the sensor close to the main unit during cold
winter months as below-freezing temperatures may
affect battery performance and signal transmission.
NOTE The transmission range may vary and is subject
to the receiving range of the main unit.
You may need to experiment with various locations to
get the best results.
BAR916HG_EN_OP.indd 11 5/8/06 11:23:21 AM