AllTrade BAR916HG - Manual (Page 13)

EN
13
ICON MEANING
The unit has contact with the
sensor and has synchronized
the time.
The unit has contact with the
sensor but the time has not been
synchronized.
The unit has lost contact with
the remote sensor but the time
is synchronized.
The unit has lost contact with the
remote sensor and the time is not
synchronized.
The unit cannot reach the remote
sensor. you first set up the unit, and whenever you press RESET.
Once complete, the reception icon will stop blinking.
In addition to the local time and calendar display, you
can also select to display the corresponding time of 130
major world cities.
The icon shown in the Clock Area indicates 2
factors:
• Connection between the main unit and the sensor
that collects RF signals ( )
• RF signal reception ( )
How these signals work together:
NOTE To force a manual search for RF clock
reception, press and hold SEARCH on the sensor
(RTGR328N) for 2 seconds.
TURN RADIO-CONTROLLED CLOCK ON / OFF
If you wish to manually set the clock, you must first
disable the radio-controlled feature. To do this, navigate
to the Clock / Alarm Area. Then, press and hold
on
the main unit for 2 seconds. To enable it, navigate to
the Clock / Alarm Area, then press and hold
for 2
seconds.
RF clock enabled:
RF clock disabled:
BAR916HG_EN_OP.indd 13 5/8/06 11:23:36 AM