AllTrade BAR916HG - Manual (Page 12)

EN
12
SENSOR DATA TRANSMISSION
Data is sent from the sensor(s) every 60 seconds. The
reception icon shown in the Temperature / Humidity Area
indicates the status.
SEARCH FOR SENSOR
To search for a Thermo / Hygro sensor, press SEL to
navigate to the Temperature / Humidity Area.
will
show next to the Area. Then, simultaneously press and
hold MEM and CH for 2 seconds.
To search for the UV sensor, press SEL to navigate to
the UVI / Barometer Area.
will show next to the Area.
Then, press and hold MEM and CH for 2 seconds.
NOTE If the sensor is still not found, check the
batteries.
CLOCK AND CALENDAR
This product tracks the time and date based on radio-
controlled signals from the RTGR328N remote sensor,
or manual settings that you enter.
1
2
3
1. RF Clock time
2. World Time city
3. World Time clock
RADIO-CONTROLLED CLOCK
The time and date are automatically updated by radio-
controlled clock signals from official time-keeping
organizations in Frankfurt (Germany) and Rugby
(England) unless you disable this feature. The signals
are collected by the remote sensor (RTGR328N)
whenever it is within 1500 km (932 miles) of a signal.
Initial reception takes 2-10 minutes, and is initiated when
ICON DESCRIPTION
Main unit is searching
for sensors.
At least 1 channel has
been found.
Sensor 1 is sending
data. (The number
shows which sensor is
selected.)
--- shows in Temp /
Humidity Area The selected sensor
cannot be found.
Search for the sensor
or check batteries.
BAR916HG_EN_OP.indd 12 5/8/06 11:23:27 AM