AMX MAX Servers - Manual (Page 38)

MAX Admin Menu
32 MAX Servers: HT Home Theater and MMS Multimedia Servers
Adding New Modules to the System
1. Select Add, then select the type of module (MAX-AOM or MAX-AVM) you are adding (FIG. 19).
2. Click OK to proceed. Next you must enter an Output Number for the new module (FIG. 20).
If you are adding a MAX-AOM (audio-only module) then the valid range depends on the type
of server you are using:
MMS-01S, -02S and -02SB servers only support one AOM module, so the output
should always be set to 1.
MMS-04S, -12S and -900 servers support up to two AOM modules, so the output
can be either 1 or 2. If you are only using one AOM with these servers, the output
should be set to 1.
MAX-HT04 and -HT12 Home Theater servers support up to two AOM modules, so
the output can be either 1 or 2. If you are only using one AOM with these servers, the
output should be set to 1.
If you are adding a MAX-AVM audio-video module, the range is 1-25 (all MAX servers
support up to 25 AVMs).
If you are adding a MAX-AVP Audio-Video Player (HT04/HT12 Servers only), the range is
1-25 (MAX-HT04 and MAX-HT12 servers support up to a total of 25 AVMs and/or AVPs).
Click OK to save your changes.
MAX-HT Home Theater Servers treat MAX-AVP Audio-Video Players exactly the
same as MAX-AVP modules, and the process of adding AVPs is the same as that for
AVPs.
MAX-AVPs are supported by HT servers only - they are not supported by MMS
servers.
FIG. 19 Add Output Module
If you are adding a MAX-AVP (MAX-HT04 and HT12 Home Theater Servers only),
select AVM from the Add Output Module menu.
FIG. 20 Add Output Module ( AOM and AVM )