AMX MAX Servers - Manual (Page 76)

Rack Mounting MAX Servers
70 MAX Servers: HT Home Theater and MMS Multimedia Servers
FIG. 64 shows the Adapter Bars properly mounted to the Rack-Rail assemblies and vertical mounting
rails in the equipment rack:
Step 6: Load the HT Server Into the Rack
Once the Rail Assemblies have been installed into the equipment rack cabinet, the server can be mounted
on the rails and slid into the rack (FIG. 65):
1. Slide the Rails (Intermediate Sections) out to their fully extended position.
2. Carefully align the Chassis Sections (mounted on the HT server) with the extended Rails.
3. Slide the server onto the extended rails. Keep the server parallel to the floor when sliding the server
rails into the rails. Tilting the server up or down could result in damage to the Slide Rails.
FIG. 63 Align the holes on the Adapter Bar to the holes on the rails in the equipment rack
FIG. 64 Adapter Bars mounted to the equipment rack
Adapter Bar
Mounting Rail in equipment rack
Align the center hole on the Adapter Bar to a center hole
Align the top hole on the Adapter Bar to the bottom hole
Align the bottom hole on the Adapter Bar to the top hole
of the upper-adjacent RU in the equipment rack.
in one of the RUs in the equipment rack.
of the lower-adjacent RU in the equipment rack.
Front mounting rail on the Rear mounting rail on the
equipment rack equipment rack