Contemporary Research ICC1-IR IR - Manual (Page 6)

Contemporary Research 6 ICC1-IR
Installation
Setting IR Control Codes (IR Type Mode)
Turn enclosure so the DIP switches are on the bottom
In most cases, it’s easier to use our Display Express software, IC Send app, or your control system to change the IR
code set you want to use. See the section on page 11 on using our software to set the IR code set.
The DIP switches S1 and S1 at the bottom of the ICC1-IR serve in two modes, IR Type, Channel Entry and Device
Number, determined by S2 Switch 6 and S2 Switch 5. In this section, you’ll set up the manufacturer’s IR codes sent
from the IR Out port. These may have been set at the factory, or you’ll need to set them yourself.
1. Apply DC power to the ICC1-IR.
2. If the unit’s device number has already been set, note the current settings for S1 switches 1-8 and S2 switches
1-4. (if this is already sounding tedious, go to page 11)
3. Set S2 Switch 6 to ON.
4. Look at the IR Control Code chart on next page and select the desired value.
5. Set S1 Switches 1 – 6 to match the value. For example to select the Sony codes,
turn on S1 switches 1 and 3, adding up to 5 to match the value in the Manufacturer IR chart below.
6. Set S1 Switch 7 to On if you want the unit to ignore the power sensor input
7. Set S1 Switch 8 to OFF for toggling Power On/Off command typical for most TVs. (There are a few international
TVs that use Key 1 for Power On)
8. Set S1 Switch 8 and S2 Switch 6 to OFF. (See Channel Entry option below)
9. If unit’s device number had been set before, return S1 switches 1-8 and S2 switches 1-4 to previous positions.
S1 Off Value On Value
1 0 1
2 0 2
3 0 4
4 0 8
5 0 16
6 0 32
7 0 - Use Power Sensor 64 - Ignore Pwr Sensor
8 0 - Toggle power 128 - Key 1 = Power On
S2
1
2
3
4
5 Channel Entry Off Modify Channel Entry
6 Device Number Mode IR Type Mode
7 Low IR power High IR power
8