AAON RN-140 - Manual (Page 109)

109
RN Series Startup Form
Date:______________
Job Name:_____________________________________________________________________
Address:______________________________________________________________________
______________________________________________________________________________
Model Number:_________________________________________________________________
Serial Number:____________________________________________ Tag:_______________
Startup Contractor:______________________________________________________________
Address:_________________________________________________
________________________________________________________
Phone:_____________
Pre Startup Checklist
Installing contractor should verify the following items.
1. Is there any visible shipping damage? Yes No
2. Is the unit level? Yes No
3. Are the unit clearances adequate for service and operation? Yes No
4. Do all access doors open freely and are the handles operational? Yes No
5. Have all electrical connections been tested for tightness? Yes No
6. Does the electrical service correspond to the unit nameplate? Yes No
7. On 208/230V units, has transformer tap been checked? Yes No
8. Has overcurrent protection been installed to match the unit nameplate
requirement?
Yes No
9. Have all set screws on the fans been tightened? Yes No
10. Do all fans rotate freely? Yes No
11. Is all copper tubing isolated so that it does not rub? Yes No
12. Has outside air rain hood been opened? Yes No
13. Have the damper assemblies been inspected? Yes No
14. Are the air filters installed with proper orientation? Yes No
15. Have condensate drain and p-trap been connected? Yes No
Supply Fan Assembly
Alignment Check Rotation Nameplate Amps________
Number hp L1 L2 L3
1
2
Band Size_____________________
VAV Controls_________________
VFD Frequency________________