ALLIED Vision Technologies Bigeye G-1100 Cool - Manual (Page 12)

AVT GigE Cameras Installation Manual V1.0.0
12
Safety instructions
Safety instructions for board level cameras (only
Manta and Prosilica GB)
Note

Read the Manta / Prosilica GB Technical Manual and these
safety instructions before use.
Abuse or misapplication of the camera may result in limited
warranty or cancellation of warranty.
Caution-ESD Board level cameras: ESD warnings
• Board level cameras are delivered without housing.
Handle the sensor board and main board with care. Do
not bend the boards. Do not touch the components or
contacts on a board. Hold a board by its edges.
• Sensor board and main board are sensitive to
electrostatic discharge. To avoid possible damage, handle
all static-sensitive boards and components in a static-
safe work area. Follow the procedures below.
• ESD (electrostatic discharge): Static electricity can
damage the sensor board or the main board of your board
level cameras. To prevent static damage, discharge static
electricity from your body before you touch any of your
broad level camera’s electronic components, such as
sensor board or main board. To do so, use a static-safe
work area with static-dissipative mat and wear a static-
dissipative wrist strap. Do not hold any components of
your board level cameras against your clothing. Even if
you are wearing a wrist strap, your body is grounded but
your clothes are not.
• Do not remove the sensor board and main board from its
anti-static packaging unless your body is grounded.
• ESD shielding: To protect the boards from radiation of
other modules or devices use a special ESD protective
housing.