ALLIED Vision Technologies Bigeye G-1100 Cool - Manual (Page 19)

AVT GigE Cameras Installation Manual V1.0.0
19
Installing hardware
[OSX] (PvAPI only)
– System Preferences
– Network
– Select Ethernet, click Advanced
– TCP/IP tab:
Configure IPv4: Manually
IPv4 Address: 169.254.100.1
Subnet Mask: 255.255.0.0
Router: Blank
Ethernet adapter optimization
5. The Ethernet adapter should be adjusted to improve system performance when
using a GigE Vision camera. This performance is related to minimizing CPU
usage and dropped or resent packets.
Edit the Ethernet adapter driver properties according to the values in the table
below. The names and availability of the properties listed may vary depending
on adapter manufacturer and model.
Default AVT GigE Vision camera factory settings configure the camera packet
size to 8228. The host adapter needs to support a packet size of equal or larger
size to stream from the camera.
Properties Value
Packet size (MTU) 8228 or larger
Interrupt Moderate Rate Extreme
Transmit buffers 256 bytes
Receive buffers Max setting available
Table 3: Ethernet adapter performance settings
Note

If adapter packet size support is limited to 1500 bytes, as on
10/100 speed NICs, the camera packet size can be reduced
using VIMBA Viewer / GigE Sample Viewer and saved to an on
board camera power up config file.
PvAPI users: See ConfigFile in the AVT GigE Camera and Driver
Attributes document.
VIMBA users: See SavedUserSets in the AVT GigE Camera and
Driver Features document.
Figure 4: Interfaces file for static IP,
Linux Ubuntu 10.04