Loading printable media – Datamax-O'Neil LP3 LABEL PRINTER User Guide User Manual
Page 10
LP 3 LABEL PRINTER USER'S GUIDE
7
Loading Printable Media
Use the following procedure to load printable media:
1. Move the printer so that the front of the printer is facing
toward you.
2. While steadying the printer, push the two arrow buttons
toward each other while opening the printhead cover
(Figure 13).
3. Move the printer so that the left side of the printer is facing
toward you.
4. Remove the media ring from the spindle by pressing the
media ring's latches while pulling the media ring toward
you (Figure 14).
5. Load the media onto the spindle. When loaded correctly,
the media should form a figure “6” as shown in Figure 15.
Media Guidelines
Media width
1” to 3.125”
Roll capacity diameter 3.5”
Media types
Linered label media, thermal paper
* Depending on the type of media used, you
may need to configure your printer. For more
information, see
.
Figure 13
Figure 14