Datamax-O'Neil LP3 LABEL PRINTER User Guide - Manual (Page 6)

LP 3 LABEL PRINTER USER'S GUIDE
3
Setting Up Your Printer
Use the following information to set up your printer:
•
Unpacking Your Printer on page 3
• Installing Batteries on page 3
• Loading Printable Media on page 7
• Printing a Self-Test on page 12
• Connecting the Printer on page 12
• Configuring the Printer on page 14
In addition to the steps outlined in each section, additional
information may be included if it applies to, or expands upon,
the step being discussed.
Unpacking Your Printer
Before using the printer, remove all packaging material and
inspect the printer for possible shipping damage.
If the printer has been damaged:
•
Contact the shipping company and file a damage report.
• Contact Datamax-O’Neil.
• Keep all shipping materials.
Installing Batteries
1. Remove any packaging material (if applicable).
2. Lift the silver battery tab and pull on the red tab to remove
the battery from the battery well (Figure 5).
3. Remove and discard the two red, battery isolator labels
(Figure 6).
Figure 6 Figure 5