Asus Motherboard AP130-E1 - Manual (Page 44)

2-24 Chapter 2: Hardware information
8. CPU, System, and Auxiliary fan connectors
(3-pin CPU-FAN, SYSTEM-FAN, AUX-FAN)
The fan connectors support cooling fans of 350mA~740mA (8.88W
max.) or a total of 1A~2.22A (26.64W max.) at +12V. Connect the fan
cables to the fan connectors on the motherboard, making sure that the
black wire of each cable matches the ground pin of the connector.
Do not forget to connect the fan cables to the fan connectors. Lack of
sufficient air flow within the system may damage the motherboard
components. These are not jumpers! DO NOT place jumper caps on
the fan connectors!
9. Serial port 2 connector (10-1 pin COM2)
This connector accommodates a second serial port using an optional
serial port bracket. Connect the bracket cable to this connector then
install the bracket into a slot opening at the back of the system chassis.
The serial port bracket (COM2) is purchased separately.
PSCH-L
®
PSCH-L Serial Port 2 (COM2) Connector
PIN 1
COM2
PSCH-L
®
PSCH-L 12-Volt Fan Connectors
GND
Rotation
+12V
CPU-FAN
AUX-FAN
SYSTEM-FAN
GND Rotation +12V
GND
Rotation
+12V