AMX AXB-TM5 - Manual (Page 10)

Connection and Wiring
6 AXB-TM5 Television Manager
4. Attach the IR shield, with IR emitter diode, to the television IR window, ensuring that the IR
emitter diode is properly positioned in the television input IR window.
5. Press firmly to activate the pressure-sensitive adhesive of the IR shield.
TV sensor connections
FIG. 8 shows how to connect the CC-XPS to the TV sensor connector to detect horizontal scan
frequencies up to 65 kHz.
PCS connections
The optional AMX Power Current Sensor (PCS) provides power sensing for equipment that does
not generate horizontal scan frequencies. Connect the optional PCS as shown in FIG. 9 for
automated power control using Send_Commands PON and POF . A PIN command must be sent to
the AXB-TM5 either from terminal mode or from within an Axcess program. If PIN is not used,
then the PCS state is received as [TM-Device, 251] for I/O 1.
AXlink data and 12 VDC power supply connections
Connect the control system's AXlink connector to the AXlink connector and an external 12 VDC
power supply on the rear panel of the AXB-TM5 as shown in FIG. 10.
For additional information concerning the IR emitter, refer to the IR Sensors and
Receivers instruction manual.
FIG. 8 TV sensor wiring connections
FIG. 9 PCS connections
GND
SENSOR
CC-IRC
TV sensor Television
connector
GND
I/O 1
I/O 2
I/O 3
I/O 4
12 VDC PWR
Input/
Output
GND
STANDBY
ON
PWR
PCS