AMX AXB-TM5 - Manual (Page 9)

Connection and Wiring
5 AXB-TM5 Television Manager
CC-IRC emitter wiring connections
FIG. 4 shows how to connect a CC-IRC IR Emitter to the IR Emitter connector on the AXB-TM5.
IR emitter to device installation
The following steps describe the installation of the IR emitter to the television IR window.
1. Using a sharp edged tool (knife blade, razor knife, etc.), separate the factory-installed shell as
shown in FIG. 5.
2. Test-fit the IR shield (FIG. 6) to the television's IR window. If necessary, use scissors and trim
the shield to fit.
3. Remove the adhesive back covering from the IR shield and place the IR emitter diode into the
mirrored recessed area (FIG. 7) of the shield.
FIG. 4 CC-IRC Emitter wiring connections
FIG. 5 Removing factory-installed shell
FIG. 6 IR shield
FIG. 7 IR emitter diode installed
GND
SIG
CC-IRC
To emitter Television
connector
IR input window
IR shield
IR emitter code
CC-IRC cable assembly