Irx-sm connections – AMX AXB-TM5 User Manual
Page 11
Connection and Wiring
7
AXB-TM5 Television Manager
Use a 12 VDC power supply when the distance between the control system and AXB-TM5 exceeds
the limits described in the Wiring Guidelines section on page 4. Make sure to connect only the
GND wire on the AXlink connector when using a 12 VDC power supply. Do not connect the PWR
wire to the AXlink connector's PWR (+) terminal.
IRX-SM connections
Connect one or more (eight maximum in parallel) optional IRX-SM sensors to the AXB-TM5 as
shown in FIG. 11. You can also use TX-series wired control panels.
FIG. 10 AXlink 12 VDC power supply wiring example
PWR
GND
PWR
GND
AXM
AXP
PWR
GND
AXM
AXP
12 VDC power
supply
If you are using power from AXlink, disconnect the wiring from the Axcess Control
System before wiring the AXB-TM5.
FIG. 11 IRX-SM connections
PWR
GND
IN
AUX
OUT
AUX OUT
+12 VDC
GND
IRX-SM #2
OUT
AUX OUT
+12 VDC
GND
IRX-SM #1
To IRX-SG
This configuration is for 40 kHz operation only.