Draw-Tite 63181 TOW BAR - Manual (Page 5)

Hook-up
1. Attach tow bar to tow bar brackets with (2) two wire-lock pins as shown below.
2. Attach tow bar coupler to 2” ball of towing vehicle.
3. Center coupler on tow bar side arms so that tow bar is symmetrical about the
centerline of the vehicles.
4. Tighten the (4) four 3/8” nuts which attach the tow bar side arms to the coupler to 31
ft-lbs.
5. Install safety chains as described in the next section.
6. Connect an adequate wiring harness so that stop lights, turn signals and tail lights
operate on towed vehicle in conjunction with towing vehicles lights.
7. Read and follow warning labels on tow bar and shown below.
5