Draw-Tite 63181 TOW BAR - Manual (Page 6)

Safety Chains
Use safety chains and quick links rated to at least 5000 lbs (purchased separately).
1. Connect safety chains to both vehicles and the tow bar itself as shown below.
2. Attach chains to tow bar with 7/16” Grade 2 U-bolts and flanged locknuts as shown
below. Tighten each flanged locknut until at least 1/8” of U-
bolt threads extend past locknut.
3. The chains at each vehicle will be looped to themselves using
quick links as shown below. The nuts on the quick links must
have full thread engagement.
4. Cross two chains under coupler and connect to chain bracket on
hitch or to frame of towing vehicle, allowing only enough slack
to permit turning.
5. Connect the other two chains to the frame of the towed vehicle
as close to the front of the vehicle as possible. Allow only e
up and down pivoting of the tow bar. nough slack to permit the
Usage Notes
• Never exceed the lowest rating of any part of your towing system.
• Use this tow bar to tow only vehicles in good condition. Do not tow vehicles with
damaged steering or suspension systems.
• Inflate tires of towed vehicle to the maximum pressure recommended by tire
manufacturer.
• Towing mirrors on both sides of towing vehicle add to safety by increasing rear
visibility and are required by state laws.
6