eLine Technology iVMS-4000 V2.03 - Manual (Page 35)

User Manual of iVMS-4000(V2.03)
5.6.2 Hardware Decode Mode Configuration
Other instruction as below:
The decode mode: ”Factory default”, ”Preview On, TV Wall On”
and ”Preview Off, TV Wall On”.
Consumption Mode: Enable the consumption mode to decode
the video stream of 73/8100 and 90/9100 series device, if the
resolution is D1, the decoding channel halve.
4000MDI decode card has two output standard: PAL & NTSC.
Decode Mode Descriptions
Factory Default
Each 4002MDI card decodes 2 channels; each 4004MDI card decodes 4
channels and so on. Support decoding and cycling play.
TV wall on & Preview on
The images from the play window of iVMS software and TV wall are
decoded by MDI card, which needs to configure in the hardware decode
configuration.
TV wall on & Preview off
The images from the TV wall are decoded by MDI card; the images from the
play window of iVMS software are decoded by CPU.
If the resolution of all the images is CIF, then the max decoding channel number is: 4 channels for each
4002MDI card, and 8 channels for 4004MDI card.
If the resolution of all the images is D1, then the max decoding channel number is: 2 channels for each
4002MDI card, and 4 channels for 4004MDI card.
Tips: Do not output more than 4 channels at CIF or 2 channels at D1 resolution from the 4002MDI card;
and do not output more than 8 channels at CIF or 4 channels at D1 resolution from the 4004MDI card.
Enable special decode mode, and enter”Setup” ”Alarm link” to set the alarm link type to “Pop up image
when alarm occurs”, which will allow the iVMS software will output the video through 4000MDI card on TV wall
when there is alarm.
Note: The video output mode of images from device and TV wall must be the same standard, or else
the video image will become abnormal.
34