Andersen Windows & Doors AN74I - Manual (Page 35)

35
OWNER’S MANUAL
SECTION 6
Warnings, Troubleshooting, Error Messages and Alarms
Pre-Cycle Error Messages (Before the ampoule is broken)
6.1. Vent Sensor Failure
6.2. Purge Sensor Failure
6.3. Pressure Sensor Failure
6.4. Vent Pump Failure
6.5. Purge Pump Failure
6.6 Cooling Fan Failure
6.7 Abator Failure
During Cycle Error Messages (After the ampoule is broken)
6.8.
Close Door
6.9. Vent Pump Failure (During the initial 12/24 hours of sterilization cycle)
6.10. Vent Pump Failure (During the 2 hour purge cycle)
6.11. Purge Pump Failure (During the 2 hour purge cycle)
Audible Alarms
6.12 Ventilation Pump Alarm
6.13 Purge Pump Alarm
6.14 Abator Alarm
Power Outage
6.15 Temporary Loss of Power
PLEASE SEE
OWNERS MANUAL
♦ The AN74 i/ix sterilizer utilizes a maximum of 36 grams of ethylene oxide gas as the
sterilizing agent in one cycle. Please refer to the MSDS for ethylene oxide included
in this manual as Appendix F, on page 67, for pre-cautions and chemical properties
related to toxicity and flammability.
♦ Do NOT open the sterilizer until the sterilization cycle is completed and the display
indicates “UNLOAD STERILIZER”.
♦ Personal protective equipment is not required for normal operation and maintenance
of this equipment.
♦ The exhaust port must be properly vented to the outside as specified starting in
Appendix B, page 46, and ending with Appendix D, page 54.
© Andersen Products Ltd